Designed and calibrated for optimum marine performance.
Designed and calibrated from Edelbrock for use in marine applications, these Edelbrock carbs comply with U.S. Coast Guard safety standards. Cast surfaces are iridited with Teflon-coated shafts and pump arms for maximum protection. Other features include modified bowl venting, specially designed throttle shafts, an accelerator pump seal, a 3/8 in. inverted flare fuel inlet fitting, tube in airhorn for fuel pump vent, a 5 1/8 in. flame arrestor flange, a universal throttle lever, and revised secondaries for improved transient performance. Also included with every Edelbrock carburetor you will receive a owner's manual. These manuals consist of two sections; Section 1, Theory of Operation and tuning procedures which will help you be prepared to develop your own individualized calibration. Section 2, Tuning procedures will take you through a step-by-step procedure that will enable you to achieve a desirable calibration. For added ease of tuning, a Calibration reference chart for your model of carburetor will be included.

Number of Barrels 4
Carburetor Flange Square bore
Choke Electric
Fuel Gasoline

Secondary Type Air valve

New or Remanufactured New

Fuel Inlet Single

CFM 600

Carburetor Finish Gold iridited

Ford Kickdown No

Throttle Linkage Type Universal


Warranty - Edelbrock Corporation products are covered by a general warranty that states that their products will be free from defects in materials and workmanship. The length of this warranty is as follows: Performer series carburetors and Race Division products (90 days), remanufactured carburetors (30 days), Tubular Exhaust Systems and Thunder Series AVS Carburetors (one year), stainless steel exhaust systems (five years), RPM series mufflers/cat-back exhaust systems and IAS strut and shock absorbers (limited lifetime warranty; finish and shock boots are not covered), and crate engines (2 years or 24,000 miles, whichever comes first). All warranties are based on the assumption that the product(s) were properly installed, subjected to normal use and service, and that they have not been modified, neglected, or used on racing or competition applications. The warranty covers only the product itself, and not the cost of installation and removal. Edelbrock's warranty card must be completed and received by Edelbrock no later than 30 days from the purchase date to validate the warranty. Cylinder heads must be returned to Edelbrock for inspection before any refund or exchange will be done.